| Pin No. | Wire Color (Typical) | Signal Description | Connection / Notes | | :--- | :--- | :--- | :--- | | | Black/Red | BATT (Battery Power) | Constant +12V (Fuse Box) | | 2 | Black/Orange | M-REL (Main Relay) | Triggers Main EFI Relay Coil | | 3 | Black/White | +B (Main Power) | Switched +12V from EFI Main Relay | | 4 | – | Not Used | | | 5 | – | Not Used | | | 6 | Blue/Yellow | FC (Fuel Pump Control) | Opens Fuel Pump Circuit (Failsafe) | | 7 | Blue/Black | RSC (ISC Valve Close) | Idle Speed Control Valve | | 8 | Blue/Red | RSO (ISC Valve Open) | Idle Speed Control Valve | | 9 | Blue | #10 (Injector 1) | Fuel Injector #1 Driver | | 10 | Yellow | #20 (Injector 2) | Fuel Injector #2 Driver | | 11 | Blue/White | RCK (Tachometer) | Tachometer Output Signal | | 12 | – | Not Used | | | 13 | Yellow/Red | ELS (Electrical Load) | Headlights/Defogger Signal | | 14 | Blue/Black | W (Warning Light) | Check Engine Light (CEL) Output | | 15 | – | Not Used | | | 16 | – | Not Used | |
Once you understand the , you can perform reliability upgrades. toyota 4afe ecu pinout
Related search suggestions provided.
Once the ECU processes sensor data, it commands actuators through dedicated output pins. The 4A-FE pinout shows distinct drivers for fuel, spark, and air control. The four pins (#10, #20, #30, #40) are switched grounds; the ECU pulls these pins to ground for precisely measured milliseconds to pulse fuel. The Igniter pin (IGT) sends a 5V trigger signal to the external igniter module, which then fires the ignition coil. For idle control, the Idle Air Control (IAC) or ISC valve (RSO, RSC, or VS1 pins) receives a duty-cycled signal to bypass air around the throttle plate. | Pin No
Before you close this article, here is a quick diagnostic cheat sheet using the pinout: Once the ECU processes sensor data, it commands