Din 16742 - Tg5 [patched]

For a in ABS (Group A) under TG5:

: It is commonly used for industrial components and structural foam molding where a balance between cost-efficiency and technical performance is needed. Key Factors : The group assigned depends on the material's modulus of elasticity (stiffness) and its rate during cooling. Pekago Covering Technology Why TG5 Matters for Your Project din 16742 - tg5

A part with a single edge gate will have shrinkage variation along the flow path. Under TG5, you must simulate this (Moldex3D, Cadmould) and adjust the nominal dimension asymmetrically (e.g., +0.10 mm / -0.18 mm instead of ±0.14 mm). For a in ABS (Group A) under TG5: